Bucket elevator equipment motor failure cause: bucket elevator is a kind of mechanical equipment in the upward transmission of conveying machinery. Bucket elevator is used for conveying powder, granular and small block materials when vertical or inclined. That it appears in the use of problems, the plane rotary screen supplier Xiaobian specific analysis and detection is as follows:
1, the proportion of the medium exceeds the configuration of the motor, the need to replace the configuration of the appropriate bucket elevator with the motor. It is suitable for lifting from low place to high place. After the supply material is put into the hopper through the shaking table, the bucket elevator will automatically run continuously and move upward. The speed of transmission can be adjusted according to the amount of transmission, and the lifting height can be selected as needed. The hopper is designed and manufactured by itself. The bucket elevator uses the hopper that is uniformly fixed on the unended traction member to vertically lift the material continuous conveying machinery. The hopper that is fixed on the traction chain or tape is used to transport the bulk material upward in the vertical or close to the vertical direction. Divided into ring chain, plate chain and belt three. It is suitable for lifting from low place to high place. After the material is put into the hopper through the shaking table, the machine automatically and continuously runs upward.
2. The scope of use (throughput, lifting stroke) exceeds the design requirements of bucket elevator. The appropriate motor should be selected according to the series type spectrum.
3, the assembly quality is poor, there is friction or the motor and the spindle are different; Check the quality of the assembly and troubleshoot the assembly. Can be based on the above conditions, one by one analysis, find out the cause of motor overheating, in accordance with the corresponding fault repair.
4, the packing gland pressure is too tight or the mechanical seal spring is too tight; Readjust the spring compression of the gland or mechanical seal. The motor of the bucket elevator needs frequent inspection and maintenance, and the electric oil bucket pump should be regularly checked and maintained. Check the power cable: internal wiring, switch, insulation resistance is normal.
The above content is brought to you by the plane rotary screen equipment factory.