Vibrating screen machine suppliers take you to understand the installation and commissioning of plane rotary screen equipment

Plane rotary screen equipment is also more and more people, about its operation and installation, today the plane rotary screen supplier Xiaobian to take you to understand.

Plane rotary screen operation and installation

(1) The plane rotary screen has been installed before leaving the factory, and the plane rotary screen can be replaced by itself in the process of use.

(2) Before the plane rotary screen boot, should first check the tightness of the compression bolt of the plane rotary screen, and the position of the material port of the plane rotary screen is positive with the feeder, and observe whether the vibration motor can rotate normally and the spring force is not impeded, check whether the layers of the screen is pressed.

(3) When the plane rotary screen access to the electrical control panel before, should first check the electrical control panel. After the line is connected, observe whether the rotating direction of the vibration motor is clockwise (Note: otherwise, the phase sequence should be changed) whether the operation is normal and there is no normal noise.

(4) Adjust the phase Angle of the upper and lower eccentric block of the vibration motor to adapt to the screening of various materials.

Vibrating screen machine supplier Xiaobian tell you installation and commissioning procedures and installation and commissioning precautions:

1. Before installing the machine, check whether the parts are complete and damaged by referring to the packing list.

2. Be sure to refer to the installation diagram for installation, which support bottom frame must be installed horizontally on the foundation, the foundation must have enough stiffness and strength, to support the plane rotary screen (large particle urea screen) of all dynamic load and static load.

3. The trunnion of the screen box can be used to lift the screen machine. The whole screen can not be hung directly on the shaker.

4. When installing the screen machine, it should be ensured that a small 75mm gap is maintained between the screen box and the hopper, the trough and other non-moving parts.

5. After the installation of the equipment, the screen surface is kept horizontal, otherwise, thin iron sheet can be adjusted between the spring seat and the supporting parts.

6. The spring must be in a vertical state, and the spring fixing frame is fixed on the trunnion of the screen box.

7 plane rotary screen (large particle urea screen) driving direction is determined to stand in the feeding end, facing the direction of material flow, observe the motor position, the left hand side is driven to the left, the right hand side is driven to the right. The plane rotary screen (large particle urea screen) adopts symmetrical design, both sides of the pulley. Changing the position of the motor can realize the change of the left and right driving direction.